Electrical Engineering and Control Systems (EC2259) Lab Manual Booklet - 2014 Edition

0
   

Anna University , Chennai
Department of Electronics and Communication Engineering

Fourth Semester

EC2259- ELECTRICAL ENGINEERING AND CONTROL SYSTEMS LABORATORY

Lab Manual Booklet - 2014 Edition

(Regulation 2008) 

(Also includes VIVA Questions)

Preface

This laboratory manual is prepared by the Department of Electronics and Communication Engineering for Electrical Engineering and Control Systems (EC 2259) laboratory. This lab manual can be used as instructional book for students, staff and instructors to assist in performing and understanding the experiments. In the manual, experiments as per syllabus are described. This manual will be available in electronic form from www.Vidyarthiplus.com website,  for the betterment of students.

Acknowledgement

We would like to express our profound gratitude and deep regards to the support offered by the Chairman Shri.A.Srinivasan. We also take this opportunity to express a deep sense of gratitude to our Principal Dr.B.Karthikeyan, M.E, Ph.D., for his valuable information and guidance, which helped us  in completing this task through various stages. We extend our hearty thanks to our head of the department B.Kartika, M.E., for her constant encouragement and constructive comments. 
Finally the valuable comments from fellow faculty and assistance provided by the department are highly acknowledged.

LIST OF EXPERIMENTS   
1. Open circuit and load characteristics of separately excited and self excited D.C.Generator.
2. Load test on DC shunt motor.
3. Swinburne’s test and speed control of DC shunt motor.
4. Load test on single phase transformer and open circuit and short circuit test on single phase transformer
5. Regulation of three phase alternator by EMF and MMF methods.
6. Load test on three phase induction motor.
7. No load and blocked rotor tests on three phase induction motor (Determination of equivalent circuit parameters and predetermination of performance characteristics at various loads)
8. Study of D.C. motor and induction motor starters.
9. Digital simulation of linear systems.
10. Stability analysis of linear system using MATLAB.
11. Study the effect of P, PI, PID controllers using MATLAB.
12. Design of lead and lag compensator.
13. Transfer function of separately excited D.C. generator. 
14. Transfer function of armature and field controlled DC motor

Attachment :

.pdf   EECS-LAB - 2014.pdf (Size: 1.92 MB / Downloads: 3,436)
New Share your Study Materials with us : Click Here

    Electrical Engineering and Control Systems (EC2259) Lab Manual Booklet - 2014 Edition